Operating instructions

- 30 -
IDEAL 7260
2.
1.
3.
A
A
Take out the cutting stick with a small screw-
driver. If needed the cutting stick can be turned
or exchanged. (The cutting stick can be used
eight times).
Replacing the cutting stick (not the blade)
•
Turn the blade depth adjustment (A) towards
the top until the blade screw recess
corresponds with the frame recess.
See page 27. (Otherwise the first cut will be
too deep).
•
Remove spanner
•
Remove the cutting stick according to top
picture.
•
Turn the cutting stick (the non-used side must
be near to the blade) and plug it into the left
holding bolt.
Danger! Risk of injury!
Cutting test after replacing the cutting stick
(not the blade)
•
Insert the paper and release the cut.
•
If the last sheet of paper is not cut along the
entire length turn the blade depth adjusting
screw (A) 1/12 downwards using a spanner.
•
If the last sheet is still not completely cut
repeat this process until the last sheet is cut
along the entire length.
•
Blade and cutting stick replacement
•