Operating instructions

- 20 -
IDEAL 7260
PSF1
F2
F3ID
CP AM E
PROGRAMM STEP
2000
1750
1500
1250
1000
750
500
250
789
456
1
0
M
C
Stop
M
E
S
Start
23
•
Operation
•
Eject function
If button
z U
is pressed the backgauge will
advance to the preset measurement, ejecting
the material to be cut, then automatically return
to the position shown on the display.
Adjust the eject-dimension
•
Press
p
and hold + press
z

e
on display.
•
Insert the desired dimension.
•
g
Store dimension.
Multiple cut
•
Enter the multiple cut size on the display
W.
•
Advance to the measurement with the
S
button.
•
Push the paper to the backgauge
C.
•
Release the cut.
•
Press
Q
button  "A" on the display
K
•
Enter the multiple cut size.
•
Press
S
button  backgauge will advance
by the multiple cut size.
•
After cutting the backgauge will advance by
the multiple cut size.
•
Pressing the
s
button shows the actual
size.
If, when inserting the multiple cut size, the
T
button is pressed instead of the
Q
the LED "M "
L
will light and after every cut the
S
button
must be pressed.
Exiting program-mode
•
Press
T
button  LED "M "
L
is cleared on
the display. The actual size is shown.
Cutting activation
Warning!
•
Run backgauge to the front for turning the
paper stack.
•
Do not interrupt the upward movement of the
blade by performing switching procedures.
•
Release blade only when LED "S"
N
has
gone out.
•
The safety area must be free.
•
Blade must always be at the top and be
covered by the clamp. Do not touch the blade
risk of injury!