Operation Manual
GB-4
OVEN AND ACCESSORIES
OVEN
1. Oven lamp
2. Control panel
3. Waveguide cover (DO NOT REMOVE)
4. Coupling
5. Oven cavity
6. Door seals and sealing surfaces
7. Door latches
8. Door opening handle
9. Grill heating element
10. Power cord
11. Ventilation openings
12. Outer cabinet
ACCESSORIES:
Check to make sure the following accessories are
provided:
13. Turntable
14. Roller stay
15. Rack
• Place the roller stay in the coupling on the floor
of the cavity, then place the turntable on to the
roller stay, ensuring it is located firmly.
• To avoid turntable damage, ensure dishes or
containers are lifted clear of the turntable rim
when removing them from the oven.
• For use of the rack, refer to the grilling sections
on pages GB-13-15.
Never touch the grill when it is hot.
NOTES:
• The waveguide cover is fragile. Care should be taken when cleaning inside the oven to ensure that it is not
damaged.
• After cooking fatty foods without a cover, always clean the cavity and especially the grill heating element
thoroughly, these must be dry and free from grease. Built-up grease may overheat and begin to smoke or
catch fire.
• Always operate the oven with the turntable and roller stay fitted correctly. This promotes thorough, even
cooking. A badly fitted turntable may rattle, may not rotate properly and could cause damage to the oven.
• The turntable rotates clockwise or anti-clockwise. The rotary direction may change each time you start the
oven. This does not affect cooking performance.
• When you order accessories, please quote both the PART NAME and MODEL NUMBER to your dealer or
SHARP approved service facility. The model number is located on the rating label, which is found on the
right hand side when you open the door.
13
1
4
WARNING: This symbol means that the surfaces are liable to get hot during use. The door, outer
cabinet, oven cavity, accessories and dishes will become very hot during operation. To prevent burns,
always use thick oven gloves.
15
9
1
2
3456
7
8
10
11
12
R-640_OM_01_EN.indd 4R-640_OM_01_EN.indd 4 2011-03-18 14:44:302011-03-18 14:44:30