User`s guide

Supplementary features
Aastra 610d 43
eud-1093/1.1 – I7.9 – 09.2009
■ Activating Ring alone
You want to specify which of your phones shall acoustically ring when you receive a call.
If your system administrator has set up a phone number with several phones for you, you can
specify which of your phones shall acoustically signal a call by using Ring alone
[a]
.
When you have activated Ring alone on a phone, the acoustic ringing tone is deactivated for all
other phones ( ). An incoming call is signalled in the display of all phones. You can answer the
call on each of your phones.
This function must be stored under a configurable key (see Chapter "Configuring keys" , page 62 ).
Setting functions by remote control
This section explains how you can change your phone's settings even if you are not directly at your
phone.
You are not at your desk and want to set various functions on your phone from a different
phone.
You can activate/deactivate many of your phone's functions by remote control from a different
phone.
The remote control is initiated using a special */# procedure. You can then enter the function
commands and */# procedures.
Note:
When you have activated Ring alone but deactivated the personal call routing for a phone in parallel, an
incoming call is not acoustically but only visually signalled.
In idle state:
Press the function key for <Ring alone>.
➔ Ring alone is activated/deactivated.
<Setting value>
Using remote control from a third-party phone:
1. Enter */# procedure #36.
2. Enter your phone number.
3. Enter your PIN.
4. Enter the */# procedure for activating/deactivating the function you want.
Press the Call key.
➔ Acknowledgement tone sounds; function is activated/deactivated.
Note:
The factory setting "0000" is not accepted. First change the PIN as described in
chapter "Changing the User PIN", page 54 or use the */# procedure *47 (see
"User’s Guide */# Procedures"). If you have forgotten your PIN, your system
administrator can reset it to the factory setting.