Product manual

Maintenance and Repair
6-9
Part 1105120-01
E 2013 Nordson Corporation
7. Set the retaining brackets in place. The placement of the retaining
brackets differs between focus and flood reflectors.
Focus Reflectors: See Figure 6-9. The edge of the reflector sits on the
springs next to the lip of the bracket. The lip wraps around the edge of
the reflector.
Line up the retaining bracket mounting holes with the three mounting
holes in the lamphead base.
Focus Reflector and Retaining Bracket Installing the Focus Retaining Bracket
Lip
Figure 6-9 Focus Reflector Installation
Flood Reflectors: See Figure 6-10. The edge of the reflector sits on
the springs next to the inside lip of the bracket and between the curved
retainers and the lip.
The lip on the flood bracket goes inside of the lamphead and wraps
around the edge of the reflector. Line up the retaining bracket mounting
holes with the three mounting holes in the lamphead base.
Flood Reflector and Retaining Bracket
Installing the Flood Retaining Bracket
Lip
Curved
Retainers
Figure 6-10 Flood Reflector Installation
8. Torque the six retaining bracket screws to 1.8−1.57 NSm
(0.87−1.16 lb-ft) to secure the retaining brackets.
9. Install the bulb and RF screen as described on page 6-6.