Product manual

Maintenance and Repair
6-8
Part 1105120-01
E 2013 Nordson Corporation
Reflector Replacement (contd)
NOTE: Great care should be taken when replacing reflectors as they are
made of glass and may break if dropped or forced.
1. Perform the Preparation procedure on page 6-5.
2. Turn or place the lamphead so that the entire bulb area is exposed and
accessible.
CAUTION: Do not touch the bulb or reflectors with bare hands. Wear clean
latex or nitrile gloves.
3. Remove the screen and bulb as described on page 6-5.
4. See Figure 6-7. Loosen the six mounting screws, then remove the two
retaining brackets from the lamphead base.
Figure 6-7 Retaining Bracket Removal
5. Carefully slide the two reflectors from the lamphead base.
Support
Inside Edge of
Reflector
Figure 6-8 Reflector Removal and Replacement
NOTE: The outside edges of the reflectors are printed with the part
number.
6. Slide the new reflectors into the lamphead base and slide the inside
edges into the notches in the white supports.