Product manual

Maintenance and Repair
6-6
Part 1105120-01
E 2013 Nordson Corporation
Bulb Replacement (contd)
Figure 6-3 RF Screen Removal
CAUTION: Do not touch the bulb or reflectors with bare hands. Wear clean,
residue-free nitrile or latex gloves.
4. See Figure 6-4. The bulb is held in place by springs inside the retaining
holes at each end of the lamp. Grasp both ends of the bulb and push
one end into its retaining hole until the other end comes free. Carefully
tilt the bulb to the side just enough to remove the retained end from the
hole. Tilting the bulb too much could break off the tip of the bulb.
5. Place one end of the new bulb into a retaining hole and carefully push
down on that end to force the spring down. Guide the other end of the
bulb into the opposite retaining hole and allow the springs to secure the
bulb in place.
6. Place the old bulb in the new bulb packaging and dispose of according
to your company disposal policies. Refer to the Section 1, Safety section
for the bulb return policy.
7. Install the RF screen on the lamphead base with the eight M4 screws.
Torque the screws to 1.18−1.57 NSm (0.87−1.16 lb-ft).
Figure 6-4 Bulb Removal and Replacement.