Product manual

Operation
4-6
Part 1105120-01
E 2013 Nordson Corporation
System Timing Sequences
NOTE: Refer to Section 5, Troubleshooting if the system fails during
startup.
Timing Sequence with Idle = Y
(Also see Table 3-5)
Powering ON the System Controller
Total Seconds
12 seconds
Turn on main disconnect switch on front panel.
Controller goes through initial boot sequence with a full display test.
When complete, controller displays OFF.
Changing system status from OFF to LAMP ON
Total Seconds
25 seconds
Press SYSTEM ON button.
Display reads WARMUP.
Display reads LMPDLY.
Display reads LAMPON.
Changing system status from LAMP ON to IDLE
Total Seconds
~ 1 second
Press STANDBY button Once.
Display reads IDLE.
NOTE: The controller automatically switches to Standby after 10 minutes in Idle
mode. Idle is a configurable mode. If not enabled, only the Standby mode is active.
Changing system status from IDLE to LAMP ON
Total Seconds
~ 2 seconds
Display reads IDLE.
Press SYSTEM ON button.
Display reads LMPDLY.
Display reads LAMPON.