Product manual

Operation
4-5
Part 1105120-01
E 2013 Nordson Corporation
DescriptionFault MessageNo.
10 DEVICENET ERROR There is a DeviceNet communication fault.
11 DEVICENET HARDWARE
FAIL
There is no communication with the DeviceNet processor.
12 MAG VOLTAGE ERROR The magnetron voltage is not within limits.
13 NETWORK COMM ERROR The control board can no longer communicate with a
previously detected system.
15 POWER CONTROL AT
LIMIT
The power control cannot control the output within 5% of the
setpoint.
16 LOW LAMPHEAD
PRESSURE
There is insufficient or no air pressure in the lamphead.
17 EXT INTERLOCK OPEN The external machine stop interlock is open or is not at
24 Vdc, depending on the jumper setting.
18 POWER UNIT OVER TEMP The system controller is over temperature.
19 RF DETECTOR MISSING The RF detector is not connected.
20 RF DETECTOR TRIPPED The RF detector has detected a high RF field.
22 LAMPHEAD OVER TEMP Lamphead temperature sensor is over temperature.
Transformer thermal switch(es) open. May be caused by
insufficient air flow through system controller cabinet.
23 HV CABLE UNPLUGGED The system controller is not communicating with the
lamphead. The high-voltage cable from the system controller
to the lamphead is disconnected or damaged.
24 LOW CURRENT ON MAG The magnetron is below 5 mA minimum current value.
25 PHASE CONTROL AT LIMIT The system controller cannot regulate to the power setpoint.
26 RF DETECTOR FAILED The RF detector is defective and must be replaced.
27 PHASE CONTROLLER
ERROR
The system control is not communicating with the phase
board.
28 MAG FILAMENT IS OPEN One of the two magnetron filaments has failed.
Resetting Faults
Operating in Local Mode: Press the Off button to reset a fault once it has
been corrected.
Operating in Remote Mode: Open and close the Reset contact to reset a
fault once it has been corrected.
NOTE: Once the fault has been corrected you can reset a fault on a unit
operating in Remote Mode from the host controlling the master unit through
either a discrete I/O or DeviceNet.