Product manual

Installation
3-25
Part 1105120-01
E 2013 Nordson Corporation
Configuration 2Configuration 1FunctionDisplay
PCTL Power control algorithm Y = Enable Power Control
mode
N = Use current control
mode (default)
If set to PCTL Y, the power control algorithm controls the total power output to reduce
the variation of power over the life of the magnetron.
PCTL N is the default and preferred method of control (current control).
LAN Language in which faults
are displayed
ENG=English FR=French
IT=Italian
GE=German
SP=Spanish
Use this setting to choose the language for fault messages. English is the default
language.
IDLE Enabling IDLE mode
allows a return to Lamp
ON mode within 3 seconds
(use the Standby
command for activation).
This is done by operating
the lamp system at a low
power, which is not
capable of curing, with
minimal heat on substrate.
IDLE N=No
Not enabled
IDLE Y=Yes
Operation of IDLE mode
(local or remote) through
Standby control. Refer to
the Operation Section for
the proper sequence.
VSPD Lampheads with an
internal blower may
incorporate variable speed
control to provide
consistent bulb
temperature.
VSPD N=No
Set to N if lamphead is not
equipped with internal
blower
VSPD Y=Yes
Enables speed control
Set to Y only if an internal
blower lamphead is used.
PWROFF POWER OFF No selection No selection
This is a message instructing you to turn the power supply switch OFF to save your
settings in flash memory.