Product manual

Installation
3-1
Part 1105120-01
E 2013 Nordson Corporation
Section 3
Installation
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Introduction
This section contains information for installing the CoolWave 2 10-inch
lamphead and system controller. Mounting and shielding are explained in
general terms due to differences for each independent installation.
Inspection and Packaging
The Nordson CoolWave system has been carefully tested, inspected, and
packaged prior to shipping. Upon receipt, inspect the shipping materials and
components for visible damage. Report any damage immediately to the
shipper and to your Nordson representative.
NOTE: When opening the packaging, please take care so that the
packaging can be re-used to ship the unit if necessary. Keep all packaging
materials together and in a location where they will not get damaged.
System Controller Installation
Mounting Guidelines
WARNING: Heavy equipment. Be careful when moving the system
controller. Use approved lifting equipment or get help. Failure to observe
this warning could result in personal injury or equipment damage.
See Figure 3-1.
S The system controller can be mounted on any stable horizontal surface.
S Install the system controller so the operator panel and disconnect switch
are easily accessible.
S The blowers mounted on the front and the rear of the system controller
and the exhaust vents on the sides must not be obstructed.