Product manual

Safety
1-8
Part 1105120-01
E 2013 Nordson Corporation
Action in the Event of a Malfunction
If a system or any equipment in a system malfunctions, shut off the system
immediately and perform the following steps:
S Disconnect and lock out electrical power.
S Identify the reason for the malfunction and correct it before restarting the
equipment.
Safety Precautions While Servicing
A qualified competent electrician must carry out all electrical maintenance
and servicing of this equipment.
WARNING: This equipment operates at high voltages up to 5000 volts dc
and is therefore potentially dangerous. The electrician servicing this
equipment must take all precautions.
WARNING: Isolate the equipment at the main, disconnect or lockout before
removing any of the cover panels.
Control System Cleaning
Keep all contactors and relays clean and free from dirt and dust. Check
them regularly.
WARNING: This equipment is not rated for explosive environments. Do not
install in extremely dusty or powder-charged work rooms. Contact your
Nordson representative if in doubt.
High Voltage Connections
Check the high-voltage connections within the equipment carefully to make
sure that these do not become dirty or coated with powder or other possible
conducting material. Clean them regularly, at least whenever the lamp is
changed, possibly more often where a particularly heavily polluted
atmosphere occurs.
Always make sure the unicable connectors are secure and tight before
applying power.
Disposal
Dispose of equipment and materials used in operation and servicing
according to local codes.
Moving and Storage
Moving or storing of the Nordson UV curing system must comply with all
applicable local and state regulations. The lamphead and system controller
should be shipped or stored in the original container or an equivalent and
kept dry and clean at all times.