Specifications

Phone: [phone]
Fax: [phone]
86
The Huskie REC-P1 is a 28.8 volt, battery operated hydraulic pump that runs on two
14.4 Volt Huskie BP-80 series batteries. The REC-P1 is supplied with a push button
remote control that allows the operator to advance, hold, and retract when needed.
The user is never committed to a full cycle and can always back off at any time during
the advance– even when the pump is under pressure. High pressure, non-conductive
hose can be attached to a 360° moveable swivel port on the pump. This swivel port
allows the user to position the hose to fit in confined aerial buckets and manholes.
Both batteries must be inserted in the pump to operate. It is recommended to operate
the pump with a 10 foot hose, up to a maximum of 20 feet. A longer hose will cause
cycle times to increase.
We recommend you specify the Huskie SC-Series flush face dripless couplers, as not
to deplete the oil in the reservoir when changing heads.
For additional ordering information, please refer to page 10.
REC-P1ROBO*PUMP
10,000 psi Battery Powered 28.8 Volt Pump
HydRauliC pumps & punCHes
Features
•Powerful28.8Volt
•OperateUptoSingleActing60TonPress
•Adjustable10,000psi
•EliminatestheNeedforACPower
•CompactandPortable
Specifications
Output 10,000 psi
Weight 23 lbs. with 2 Batteries
Size 16”L x 6”H x 10”D
Crimping Estimates
2 BP-80
Using a 10 ft. Hose
andEP-60Won
1272 ACSR
12
No Load Cycle
Time
Advance 25 Sec., Retract
30 Sec.
Optional Accessories
FS-14 FootSwitch,p.88
URH-14 Remote Handle, p. 88
REC-P1CASE Steel Carrying Case, p. 94