Specifications

Phone: [phone]
Fax: [phone]
34
REC-530YROBO*CUT
TM
6.6 Ton Cutting Tool with 1-3/16” Jaw Opening
The REC-530Y was designed to cut ACSR cables up to 336 MCM, as well as
copper cables up to 500 MCM and aluminum cables up to 1.18” outside diameter.
The hydraulic system features a rapid advance for reduced cycle times. All cuts are
clean with a minimal amount of cable distortion, which allows for easy connector
installation on cables. The open “C” type jaw is very convenient for the operator
when reaching out to cut cable opposed to latching the cutter jaw around the cable.
The head can be rotated 180° for greater maneuverability in tight working quarters.
The keeper plate on the REC-530Y prevents jaws from spreading apart when cutting
ACSR.
NOTE: This tool is not recommended for cutting 4/0 Penguin or 3/0 Pigeon ACSR
Cables, see cutting guide on page 96.
For additional ordering information, please refer to page 10.
Features
•OpenScissorJawforEasyCableInsertion
•TestedUpto75kV
•OneHandOperation
•RotationalHead
•RapidAdvance
•ErgonomicallyBalanced
•ErgonomicPistolGripHandle
•WeatherResistantHousing
•OverloadBypassProtection
•5YearWarrantyonTool,Battery&Charger
Specifications
Output 6.6 Ton
Weight 11.4 lbs. with Battery
Size 15”L x 12”H x 2.5”W
JawOpening 1-3/16”
Cutting Estimates
BP-80
500 MCM Cu 110
Cutting Capacities
Bar DO NOT CUT
ACSR 336 MCM
Copper 500 MCM*
Aluminum 1.18” O.D.
Standard Guy Wire 3/8” Max.
*Will not cut ALL 500 MCM copper cable-consult factory.
Due to material composition, the ratings are to be used as
a guide. Actual capacity may vary due to “bypass” feature.
Robo batteRy opeRated tools - ReC line