User`s guide
bizhub C652/C652DS/C552/C552DS/C452 5-12
5.1 Basic
5
5.1.6 Post Inserter
When the Post Inserter PI-505 is installed on the Finisher FS-526, you can manually operate the Finisher
FS-526 using the post inserter control panel.
Reference
- Only the lower tray can be used as the output tray. The upper tray is not available.
Keys on control panel
Position Setting Configure desired staple or hole-punch positions.
Select Auto, and the machine automatically judges the staple or punch posi-
tions for the paper relative to the original direction loaded.
• A staple or hole-punch position is set along the long side of the paper if the
original length is 11-11/16 inch (297 mm) or less.
• Staple or hole-punch positions are set along the short side of the paper if
the original length is more than 11-11/16 inch (297 mm).
• Staple or punching positions are set on the upper or left-side end.
• Be sure to load the original so that its top side is placed in the back.
• If desired, press [Original Direction], and then select the original direction.
Settings
No. Name
1 Corner staple lamp
2 Center staple & fold lamp
3 [Finishing] key
4 2-hole lamp
5 3-hole lamp
6 [Select punch] key
7 [Start/stop] key
8 4-hole lamp
9 Tri-fold lamp
10 2 position staple lamp
763 5421
8910