User`s guide

bizhub C652/C652DS/C552/C552DS/C452 7-18
7.1 System Settings
7
Horizontal Punch (Z-Fold) Position Adjustment
Adjust the horizontal position of the punched holes for each paper size.
0 Before making any adjustments, create a sample using the punch settings. Adjust the center staple
position while checking the created sample.
0 This adjustment is available if the Z Folding Unit is installed.
1 Select [Utility/Counter] ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment] ö
[Finisher Adjustment] ö [Horizontal Punch (Z-Fold) Position Adjustment].
2 Press [+] or [-] to adjust the punched hole position while checking the sample.
3 Press [OK].
4 Create a sample, and check the print result.
1st Z-Fold Position Adjustment
Adjust the first paper folding position for each paper size when using the Z-fold function.
0 Before making any adjustments, create a sample using the Z-fold function. Adjust the center staple
position while checking the created sample.
0 This adjustment is available if the Z Folding Unit is installed.
1 Select [Utility/Counter] ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment] ö
[Finisher Adjustment] ö [1st Z-Fold Position Adjustment].
2 While checking the sample, press [+] or [-] to adjust the first folding position.
3 Press [OK].
4 Create a sample, and check the print result.
1st Z-Fold Position