User`s guide

bizhub C652/C652DS/C552/C552DS/C452 7-10
7.1 System Settings
7
Finisher Adjustment Adjust the staple, folding, and punch position of the finisher.
This button appears only when the finisher is installed.
d Reference
Create a sample in advance, and then adjust them while
checking the sample.
Center Staple Position p. 7-14
Half-Fold Position p. 7-15
Tri-Fold Position Adjustment p. 7-15
(This item is displayed when the Fin-
isher FS-526 and Saddle Stitcher SD-
508 are installed.)
Punch Vertical Position Adjust-
ment
p. 7-16
(This item is displayed when the Fin-
isher FS-526 and Punch Kit PK-516
are installed.)
Punch Horizontal Position Ad-
justment
p. 7-16
Punch Regist Loop Size Adjust-
ment
p. 7-17
Punch Edge Sensor Adjustment p. 7-17
(This item is displayed when the Fin-
isher FS-526 and Punch Kit PK-516
are installed.)
Vertical Punch (Z-Fold) Position
Adjustment
p. 7-17
(This item is displayed when Z Folding
Unit is installed.)
Horizontal Punch (Z-Fold) Posi-
tion Adjustment
p. 7-18
(This item is displayed when Z Folding
Unit is installed.)
1st Z-Fold Position Adjustment p. 7-18
(This item is displayed when Z Folding
Unit is installed.)
2nd Z-Fold Position Adjustment p. 7-19
(This item is displayed when Z Folding
Unit is installed.)
Punch Unit Size Detect Sensor p. 7-19
(This item is displayed when Z Folding
Unit is installed.)
Post Inserter Tray Size Adjust-
ment
Adjust the paper size to be used in the
Post Inserter. You can specify differ-
ent paper sizes for the upper and low-
er trays. This button appears when the
Post Inserter PI-505 is installed.
Density Adjustment Correct the toner amount to be used by color depending on the paper
type.
• To correct the toner amount to be used in the black print mode, press
[Black Image Density].
Image Stabilization Image Stabilization Only Press the [Start] key to stabilize imag-
es.
Pressing the [Image Stabilization Only]
button executes normal image stabili-
zation.
If a good result was not achieved after
the [Image Stabilization Only] button
was pressed, execute [Initialize + Im-
age Stabilization].
Settings