Instruction manual

4 Measurement

Operation

Press the MNT key in the measurement mode.

The sub-display shows “dFct”. (The measurement display keep showing a measured value.)

2. Press the UP/DOWN key to display on the sub-display.

The setting items are displayed in the order shown in Table 8.

3. Press the ENT key.

Now you can change the setting.

4. Change the setting referring to the instruction page of the selected item.

Tip

If you do not operate any keys for 10 seconds during item selection (step 2. mentioned above), this

function is closed automatically (the display, returns to the normal measurement status).

During setting change (step 3. or later), this function is always open.