Instruction manual

4 Measurement
46
4.4 Control value setup menu
This menu allows you to change the following control-related settings while performing
measurements in the measurement mode.
Table 8 Contact output: setting items
Display Item Description Reference Remarks
Number of data
used for moving
average
Select the number of data used for moving average,
which is performed to display measured values.
page 28
Control value
Set the control value, used as the criterion for
switching the relay output ON/OFF.
page 36
*
or
Control width
Set the control widths:
z When the control width type is “d.diF”.
Set the width (1.diF) from the control value at the
center.
z When the control width type is “S.diF”.
The width under the control value (1.udF) and the
width over the control value (1.odF).
page 38
Delay time
(Relay ON)
Set the alarm output duration from the start until the C-
NO contact output turns ON (unit: seconds)
page 39
Delay time
(Relay OFF)
Set the alarm clear duration from the cancellation until
the C-NO contact output turns OFF (unit: seconds)
page 39
Control value
Set the control value, used as the criterion for
switching the relay output ON/OFF.
page 36
or
Control width
Set the control widths:
z When the control width type is “d.diF”.
Set the width (2.diF) from the control value at the
center.
z When the control width type is “S.diF”.
The width under the control value (2.udF) and the
width over the control value (2.odF).
page 38
Delay time
(Relay ON)
Set the alarm output duration from the start until the C-
NO contact output turns ON (unit: seconds)
page 39
Delay time
(Relay OFF)
Set the alarm clear duration from the cancellation until
the C-NO contact output turns OFF (unit: seconds)
page 39
*: For the options available for the selected control target, refer to “ Control targets and their
available options” (page 32).