Instruction manual

4 Measurement

 Delay time setting for relay ON

Set the alarm output duration from the start until the C-NO contact output turns ON (unit:

seconds).

1. Open the basic setup menu and press the UP/DOWN keys to display the control

target setting for R1 on the panel, referring to “ How to open basic setup menus”

(page 19).

The setup item selection screen is displayed on the measurement display, showing the

display for control target setting, “1.SEL”.

2. Press the UP/DOWN key to display “1.ond” on the measurement display, and then

press the ENT key.

The sub-display starts blinking. Now you can change the setting.

3. Press the UP/DOWN key to set the delay time (seconds).

UP key : Increments the value by one second.

DOWN key : Decrements the value by one second.

The allowable value is 0 seconds to 600 seconds.

4. Press the ENTER key to establish the setting.

Tip

z To set another item of relay output 1 setting next, press the UP/DOWN key to display it.

z To select another setting item, press the MEAS key.

 Delay time setting for relay OFF

Set the alarm clear duration from the cancellation until the C-NO contact output turns OFF

(unit: seconds).