Instruction manual

4 Measurement

4.2.3 Display method

 Sub-display setting

Select the item to be displayed on the sub-display during measurement.

1. Open the basic setup menu and press the UP/DOWN keys to display the current

sub-display setting (as below) on the panel, referring to “ How to open basic

setup menus” (page 19).

The setup item selection screen is displayed on the measurement display, showing the

display for sub-display setting, “S.dSP”.

2. Press the ENT key.

The sub-display starts blinking. Now you can change the setting.

3. Press the UP/DOWN key to select a setting.

no :Nothing is displayed.

1.Set :Control value of relay 1

2.Set :Control value of relay 2

t :Temperature

4. Press the ENTER key to establish the setting.

Tip

z To set another item in the display setting next, press the DOWN key to display it.

z To return to the basic setup menu, press the MEAS key.

 Measurement range cut ON/OFF

Specify whether values outside the measurement range, are displayed or not.

1. Open the basic setup menu and press the UP/DOWN keys to display the current

sub-display setting on the panel, referring to “ How to open basic setup menus”

(page 19).

The setup item selection screen is displayed on the measurement display, showing the

display for sub-display setting, “S.dSP”.

2. Press the DOWN key to display “r.cut” on the measurement display, and press the

ENT key.

The sub-display starts blinking. Now you can change the setting.

3. Press the UP/DOWN key to select a setting.

UP key : YES : Values outside the measurement range are not displayed.

DOWN key : no : Values outside the measurement range are displayed.

4. Press the ENTER key to establish the setting.

Tip

z To set another item in the display setting next, press the UP/DOWN key to display it.

z To return to the basic setup menu, press the MEAS key.

← Current setting