Instruction manual

4 Measurement
20
Tip
Press the MEAS key to return to the menu one tier up.
To return to the basic setup menu from the setup screen, press the MEAS key repeatedly until “SEt” is
shown on the measurement display and nothing is shown on the sub-display, and then press the ENT
key.
Measurement
conditions
Unit selection page 24
Measurement range setting page 24
Selection of calculation
method of temperature
compensation
page 25
Temperature coefficient
setting
page 26
Available only when
“t.CoE” has been
selected for
calculation method of
temperature
compensation.
Reference temperature
setting
page 27
Available only when
“PUrE”, “nACl”, or
“t.CoE” has been
selected for
calculation method of
temperature
compensation.
TDS conversion coefficient
setting
page 27
Available only when
“tdS” has been
selected for unit
selection.
Number of moving average
times (dumping factor)
page 28
Display setting
Sub-display setting page 29
Display outside the
measurement range
page 29
Decimal place selection page 30
Relay output: R1/
R2
Control target selection page 33
*
Safety factor for USP
criterial value
page 33
Reverse control output page 35
Control method page 36
Control value page 36
Control width type page 37
Control width page 38
Delay time (for relay ON) page 39
Delay time (for relay OFF) page 39
Transmission
output
Transmission output page 40
*: For the options available for the selected control target, refer to “ Control targets
and their available options” (page 32).
Display Basic setup item Description Reference Remarks