Instruction manual

2 Installation

2.2 Installation procedure

Mount the instrument on a control panel.

The panel thickness should be 1.0 mm to 9.0 mm.

Cut a square with dimensions shown in the figure below from the control panel.

When installing the instruments in a row, leave an interval of 70 mm or more horizontally and

130 mm or more vertically between the square openings.

 Mounting

Insert the instrument into the square opening and secure it with fixtures.

1. Insert the instrument body from into the opening the front of the control panel.

2. Attach one of the two fixtures on the instrument, fitting its notches into the grooves

located on the top and bottom of the body case.

3. Attach the other fixture, in the same way.

4. Slide the both fixtures to the front panel to secure the instrument body.

Note

The gasket is a consumable. Replace it with a new one when its holding power has become weak.

[ Unit: mm ]

(or more)

Grooves

Fixture

Fixtures (after the

installation)

Front panel

Grooves

Notches

Gasket