User`s manual

SECTION 3: WIRING AND INSTALLATION T200 User's Manual
PAGE 3-65
3.14.5 Terminating the Motor Cable Shield, for CE-Compliance (T200-3/4/5 only)
The EMC Brackets shall be used where CE-Compliance under the EMC Directive is required, for the T200-3/4/5 units
only. Figure 3.36 below shows how to strip back cabling insulation to expose the shield. Clamp the shield securely
under the EMC-Bracket to ensure a good high frequency contact.
Figure 3.36:- Terminating the Motor Cabling for EMC CE-Compliance
This section should be read by users who require their installation to
comply with the EMC-Directive of the EU.
Required for
CE-Compliance