Technical data

5. place end plate (driver end) over motor shaft as
shown in Fig. G. Locate the end plate in the
annular groove at the rear of the coupling guard
haif (driver end) and secure with a bolt. nut, and
two (2) washers through the round hole at the
rear of the guard half. Finger tighten only.
.
Fig. G
6. Adjust length of coupling guard to completely cover
shafts and coupling as shown in Fig. H by sliding
coupling guard half (driver end) towards motor.
After adjusting guard length, secure with bolt, nut
and two (2) washers through the slotted holes at
the center of the guard and tighten. Check all
nuts on the guard assembly for tightness.
Before assembly or disassembly of the
coupling guard is parformad the motor must be
da-ane~hd, the motor conirvller/starter put in
a locked-out posit/on and a caution tag placed
at the startar indicating the disconnect
Replace coupling guard before resuming
normal operation if the pump. Goulds Pumps,
Inc. assumes no liability for avoiding this
prat2tiCe.
Disassembly
The coupling guard must be removed for certain
maintenance and adjustments to the pump, such as
adjustment of the coupling, impeller clearance
adjustment, etc. The coupling guard should be
replaced after maintenance is completed.
DO NOT resume normal pump operation with the
coupling guard removed.
] NOTE= Refer to JIlustmtions for assembly in
nwarse order.
1.
Remove nut, bolt, and washers from center slotted
hole in the coupling guard. Slide motor end
coupling guard half towards pump. Fig. H.
2. Remove nut, bolt, and washers from coupling guard
half (driver end), and remove end plate. Fig. G.
3. Spread bottom of coupling guard half slightly and lift
off. Fig. F.
4. Remove remaining nut, bolt, and washers from
coupling guard half (pump end). Spread bottom
of coupling guard half slightly and lift off. Fig. C.
This completes disassembly of the coupling guard.
NOTE: lt is not necessary to remove the end
pIate (pump end) from the pump bearfng
housing. The bearing housing tap bolts are
accessible without removing the end plate in
case maintenance of internal pump parts is
necessary. Before removing the pump bearing
housing, refer to the Goulds operations and
maintenance manual for your particular pump.
85