Technical data

8. install inboard bearing (169A) on shaft (122)

(fig. 87).

NOTE: Regreaseabie bearing has a single

shield. The inboard bearing is installed with

shield away from impeller.

NOTE: There are several methods used to

install bearings, The recommended method is

to use an induction heater that heats as wei/ as

demagnetizes the bearings.

Wear insulated gloves when using a bearing

heater. Bearings will get hot and can cause

physical injury.

NOTE: Coat internal surfaces of bearings with

lubricant to be used in service.

9. Install new O-ring (496) (Fig. 88).

10. lnstali outboard labyrinth oil seal (332A) into end

cover (109A). It is an O-ring fit. Position the

labyrinth seal drain slots at the bottom 6 o’clock

position (Fig. 88).

:fO’ Make sure the keyway edges are free of

NOTE: Cover the keyway lengthwise with a

piece of electrical tape prior to installing the

labyrinth seal.

73is will protect the O-rings.

496

324

109A

Fig. 88

11. Coat outside of bearing housing (134) ‘with oil.

12. Coat all internal surfaces of bearing frame (228A)

with oil.

13. Install shaft assembly into frame (228A,). Check

shaft for free turning (Fig. 89).

14. Install clamping bolts (370C) into bearing housing

(134). Hand tighten.

15. dnstall jacking bolts (370D) with locking nuts (423)

into housing (134). Hand tighten.

16. Attach bearing frame foot (241) with bolts (37OF).

Hand tighten.

Fig. 89