Technical data

Bearing Housing
1.
Inspect-bearing housing (134) bore according to
Table 8. Replace if dimensions exceed Table 8
values.
2. Visually inspect for cracks and pits.
STX, MTX - Snap ring groove must not be
cracked (Fig. 71).
LTX - Grooves and holes must be clear (Fig. 72).
XLT-X, Xl 7 - Gasket surface must be clean (Fig. 73).
Fig. 71
Fig. 73
Labyrinth Seals
1.
Labyrinth seal (332A. 333A) O-rings should be
inspected for cuts and cracks. Replace as
needed.
49