Technical data

..-
IN-
PLASTICS, INC.
HERCULINE SPECIFICATIONS
Premium Grade
Lining Material
Herculine linear low density polyethylene is produced from high quality LLDPE
resin. Herculine LLDPE has excellent chemical resistance, environmental stress
crack resistance, dimensional stability, and thermal aging characteristics.
Herculine LLDPE contains approximately 97.5 % polymer and 2.5% carbon black,
anti-oxidants and heat stabilizers and contains no additives, fillers or extenders.
PROPERTIES
TEST METHOD
MINIMUM AVERAGE R.0L.L VALUES
Thickness, mils ASTMD751 20 30 40 60
Resin Density (g/cc)
Melt Flow Index (g/10 minutes, max)
Tensile Properties
ASTM D 1505
ASTM D 1238
ASTM D638
(mod. per NSF 54)
0.915 0.915 0.!915 0.915
0.60 0.60 0.60 0.60
,,- Tensile Strength at Yield @pi)
32 48 64 96
Tensile Strength at Break @pi)
85 127 1'70 255
Elongation at Break (percent)
2.0” Gauge Length 800 800
800 800
Elongation at Break (percent)
2.5” Gauge Length 640 640
640 640
Modulus of Elasticity (2% Secant) (psi)
30,000 30,000 30,000 30,000
Tear Strength (Ibs)
ASTM D1004 11 16 22 33
Puncture Resistance (Ibs)
FTMS 101 Method 2065
26 37 52 75
AS-l-MD4833 34. 51
68 102
Carbon Black Content (percent)
AS-I34 D 1603 2-3 2-3
2-3 2-3
Carbon Black Dispersion
ASTM D 3015 Al,A2,Bl Al&&B1 Al&&B1 Al,A2,Bl
Low Temperature Brittleness (“F)
AS-l-M D 746
c-94 c-94 < -94
c-94
Environmental Stress Crack (hrs, min.)
ASTM D 1693 2,000 2,000 2,000 2,000
(lo%, Igepal, 5O’C)
Dimensional Stabiliw (uercent)
ASTM D 1204 +-3 -c3
23 22
Note: All values are minimum average roll except when shown as minimum or maximum. This data is provided for informational purposes only. In-Line
Plastics makes no warranties as to the fitness for a specific use or merchantability of products referred tc
IO guarantee of satisfactory results from reliance
upon contained information or recommendation and disclaims all liability for resulting loss or damage.
12247-B FM 529 *
Houston, Texas 77041
[phone] * Fax [phone]
- 364-7688 * Fax (800)
[phone]