Technical data
Table Of Contents
- Introduction
- Getting Started
- Flip Closed
- Flip Open Guidelines
- Phone
- Contacts
- Messaging
- Calendar
- WAP Services
- Getting started with e-mail and WAP
- E-mail set up
- Automatically set up service provider and e-mail
- Manually set up service provider and e-mail
- Manually set up a service provider
- Manually set up e-mail
- Sending an e-mail for the first time
- Using e-mail with several configurations installed
- Setting up WAP Services
- WAP Profiles
- Automatically set up WAP
- Manually set up WAP
- Using WAP for the first time
- Using WAP with several configurations installed
- Locating settings in Windows 95 or 98
- Trusted Certificates
- Homepage
- Extras
- R380 Communications Suite
- Troubleshooting
- Important Information
- Index
8Getting Started
The operational modes are as follows:
1.
Flip closed.
2.
Flip open.
It is recommended that you charge the battery for 4 hours before you
use the R380e for the first time.
The first time you charge a new battery, or a completely discharged
battery, it may take a few minutes before you get any indication that
the battery is being charged (the top indicator does not light up and
the battery meter does not appear in the display). However, after a
short delay, both the top indicator and the battery meter will operate.
Note: You cannot turn on the R380e before the indicator lights up
and the battery meter appears in the display.
A battery that has not been used for a longer period needs to be
completely discharged and then recharged 2-3 times before reaching
full capacity. Should you need to discharge the battery, simply use
your R380e as usual until the battery runs low.
The Battery
Volume slider key
Voice memo key
Power on/off key
Status indicator
Call Call log Settings Online
services
New
ink note
A-Z
Program tabs
Title bar Program icons