Technical data

Phone 73
Note: If a recording sequence is cancelled during the recording of
one of the Answer or Busy commands, this will cause the deletion of
both Answer and Busy commands.
To record a new voice command or edit an existing voice
command:
1.
Tap
Voice commands
in the Telephony/Settings/Voice Control
directory. The Voice commands view appears in the display.
2.
To record a new voice command, tap and select
New
. The
New voice command view appears in the display.
Alternatively, you can edit an existing voice command, scroll and
select the voice command you want to edit. The Edit voice
command view appears in the display.
3.
Select
Name:
and
Number:
and enter a name and phone number for
the voice command or tap and select
Lookup from contacts
. The
Select contact view appears in the display. Use the left and right
Alphabet scroll arrows and the up and down scroll arrows to select
a contact.
4.
Tap and select
Record
.
If you have chosen to edit a voice command, you are warned that a
voice command already exists and you are asked the question
“
Overwrite?
”. Select
Yes
to proceed with recording a new voice
command.
You are asked to “Speak after beep”.
5.
Speak the command that you want to use for the contact. If speech
is detected, a “Accept voice command?” view appears in the
display. Select
Yes
to save the command. If no speech is detected,
a “Speech not detected” message appears in the display asking
you to try again. Select
OK.
6.
Tap on the toolbar to implement and save the new settings. If
no phone number has been entered then you are asked to “Please
enter a phone number”. Select
OK
and enter a phone number. If no
voice command has been recorded, a message appears in the
display stating “Voice command not recorded” and asking
“Record now?”. Select
Yes
and repeat step 5 to record a voice
command. If
No
is selected or all fields contain an entry, then the
display returns to the Voice commands view.
Note: New voice command entries cannot be saved until a telephone
number has been entered.