Technical data
Table Of Contents
- Introduction
- Getting Started
- Flip Closed
- Flip Open Guidelines
- Phone
- Contacts
- Messaging
- Calendar
- WAP Services
- Getting started with e-mail and WAP
- E-mail set up
- Automatically set up service provider and e-mail
- Manually set up service provider and e-mail
- Manually set up a service provider
- Manually set up e-mail
- Sending an e-mail for the first time
- Using e-mail with several configurations installed
- Setting up WAP Services
- WAP Profiles
- Automatically set up WAP
- Manually set up WAP
- Using WAP for the first time
- Using WAP with several configurations installed
- Locating settings in Windows 95 or 98
- Trusted Certificates
- Homepage
- Extras
- R380 Communications Suite
- Troubleshooting
- Important Information
- Index
Getting Started 23
Note: The digits are not displayed and are shown as asterisks (*) for
security protection. A maximum of ten attempts are usually allowed.
Contact your network operator if unsuccessful. Emergency calls are
still available in this state.
2.
If the unblocking key is accepted, a new PIN code entry display is
shown. Enter your PIN code and then press .
Phone lock code
The phone lock activates an identification number to authenticate and
protect against unauthorised usage of your R380e if it is stolen and
the SIM card is exchanged. It is not activated when you buy the
phone. You can change the phone lock code (default is 0000) to any
three to eight-digit personal code.
The Phone lock has three possible settings:
•
Off
, no Phone lock is activated.
•
Automatic
, the Phone lock is activated when the SIM card is
changed.
•
On
, the Phone lock is activated and entry is required when turning
the phone on.
See “To change the phone lock code:” on page 82 for more
information.