Technical data
Table Of Contents
- Introduction
- Getting Started
- Flip Closed
- Flip Open Guidelines
- Phone
- Contacts
- Messaging
- Calendar
- WAP Services
- Getting started with e-mail and WAP
- E-mail set up
- Automatically set up service provider and e-mail
- Manually set up service provider and e-mail
- Manually set up a service provider
- Manually set up e-mail
- Sending an e-mail for the first time
- Using e-mail with several configurations installed
- Setting up WAP Services
- WAP Profiles
- Automatically set up WAP
- Manually set up WAP
- Using WAP for the first time
- Using WAP with several configurations installed
- Locating settings in Windows 95 or 98
- Trusted Certificates
- Homepage
- Extras
- R380 Communications Suite
- Troubleshooting
- Important Information
- Index
12 Getting Started
3.
Slide the SIM card into the SIM card holder.
4.
Replace the battery.
Note: If you already have a SIM card that contains phone book
entries then this information can be imported to your R380e. See
“SIM card phone book import” on page 21.
To remove the SIM card:
Warning! Always disconnect the charger and other accessories from
your phone before inserting and removing your SIM card.
1.
Ensure that the R380e is turned off and the flip is closed.
2.
Remove the battery.
3.
Slide the SIM card out of the SIM card holder.
The
NO
button on your keypad turns your R380e on or off.
Tip! The term press and hold is equivalent to a key press time of
approximately 2 seconds.
To turn your R380e on:
1.
Ensure that you have inserted your SIM card into your R380e, the
battery is charged and that the flip is closed.
2.
Press and hold until you hear a tone and the display turns
on.
To turn your R380e off:
•
In standby mode, press and hold until you hear a tone.
Turning on and off