Operating instructions

18
Hydraulic oil – suitable brands: (Viscosity: 46 mm
2
/s at 40
o
C)
Manufacturer’s: Substitute oils:
Castrol Hyspin AVH 46
Mobil DTE 16
Renolin B 46 - HVI Shell TELLUS T46
BIPI Energol SFA 46
SETRAL Poclain
5.5 OIL FILTER MAINTENANCE
• Check and/or clean the oil filter when the first oil change is performed. Presence of small aluminum partic-
les, caused by running-in of the pump is expected.
• Clean the filter insert using gasoline. Work in open areas and take necessary precautions to prevent fire.
Using an air compressor, blow the filter insert from inside out.
• Filter insert must be replaced only if the filter gets mechanically damaged.
• Bad filter permeability is shown on the filter gauge – if the gauge indicator is in the red zone when oil is
heated to operating temperature. Change the oil filter
5.6 LUBRICATION OF THE ANGLE MULTIPLICATION GEAR (RCA 380)
• Oil quantity and grade: 1.2 l (0,32 gallon), SAE 75 (Renolin CLP 100 DIN 51 517/13)
• Replace the oil when changing the reduction gear bearings.
5.7 CUTTING CHAIN LUBRICATION
Never operate the machine without lubricating the chain first!
Chain lubrication oil quantity: 8 L
Approximate oil consumption: (0.6-1.0) L/h
Quality chain lubrication oils with viscosity grade of 95 mm
2
/s at 40ºC are recommended.
Never use used oils!
The flow of the cutting chain lubrication oil can be regulated depending on
the oil quality, using a regulation screw (Figure: 18). It is factory set to
maximum!
18