Operating instructions

The maximum allowable speed of the tractor

when transporting the machine on the rut or off-

road is 10 km/h (12 mph) and 40 km/h (25 mph),

when the tractor is driven on the asphalt roads!

3.4 TRANSPORT POSITION OF THE MACHINE

4 OPERATING THE FIREWOOD PROCESSOR

The machine must be operated by one person only. Please ensure that there is nobody else in the near

vicinity of the machine working area.

4.1 NOISE

Machine operator is exposed to the following noise levels, during the machine operation (measured near the

ear of the machine operator):

4.2 LOG FEEDING

The in-feed conveyor must be placed in a horizontal working position before operation of the machine:

•

Pull out the safety pin (10-Figure:6)

•

Remove the support limiter (12-Figure:6)

•

Lower the in-feed conveyor (A-Figure:6) in horizontal position and support it using the supporting leg

(11-Figure:6)

•

Set the supporting leg so that the upper rod on the conveyor belt in the middle of the feed conveyor is

slightly elevated above the table (already factory set)..

Activate the feeding by pushing the sawbar activation handle (H-Figure: 1) from the upper position (neutral

position) forward - away from yourself; you can stop it at any time (when the log reaches length limiter), by

returning the handle to the neutral position.

In case you don’t stop the feeding after the log reaches the length limiter, you can damage the in-feed

conveyor belt.

The in-feed conveyor can be additionally operated with the handle for setting its rotating direction (D-Figure-

1). Using this handle, the conveyor belt can be activated in either direction.

Therefore, it is mandatory to wear hearing protectors while operating the machine.

Driving at

unsuitable

speeds for the

road conditi-

ons can cause

damages to

the machine

or the tractor.

RCA 380 RCA 380 E

Idling mode:

87 dB (A) 88 dB (A)

Operation mode:

92 dB (A) 96 dB (A)