Instruction manual

MS 362 C
English
42
Removing the shroud
N Move the Master Control lever to
stop position (0)
N Push the hand guard forward – the
chain is locked.
N Open the twist locks (1) by turning
them 1/4 turn counterclockwise with
the combination wrench.
N Remove the shroud (2).
Removing the fan housing
N Take out the screws (1).
N Push the hand guard upwards.
N Pull the underside of the fan
housing away from the crankcase
and remove it downwards.
Replacing a broken starter rope
N Use a screwdriver or suitable pliers
to remove the spring clip (2) from
the starter post.
N Carefully remove the rope rotor with
washer (3) and pawls (4).
Models with ElastoStart
N Use a screwdriver to pry the rope
out of the starter grip.
N Remove the remaining rope from
the rotor and starter grip.
N Thread the new rope through the
top of the starter grip.
Models without ElastoStart
N Use a screwdriver to pry the rope
out of the starter grip.
N Remove the remaining rope from
the rotor and starter grip.
N Thread the new rope through the
starter grip and tie one of the special
knots shown.
N Pull the knot back into the grip.
Replacing the Starter Rope
and Rewind Spring
1
1
1
001BA199 KN
2
The rewind spring may pop out
and uncoil during this operation –
take care to reduce risk of injury.
1
1
1
1
0001BA010 KN
4
4
3
2
001BA096 KN
213BA019 KN
213BA018 KN