Instruction manual

2
1. Operation of ZM-300 Main Menu 2-23
LCD Control Terminal Operations
3-4. Messages during Data Transfer
If an error occurs during data transfer, the
message window shown on the right is displayed.
The kinds and the contents of the messages are shown below. The same messages are
used for the memory card and CF card. When using the CF card, the “memory card” in the
explanation should read as the “CF card.”
OK
Data discrepant
Messages Contents
Work normally finished. The specified operation has been concluded normally.
ZM-1REC not connecting CREC is not connecting when selecting a modular jack.
ZM-1REC Communication Error A communication error occurred between ZM-300 and ZM-1REC when
selecting a modular jack.
Memory-Card not setting A memory card is not inserted.
Memory-Card Capacity over Cannot write the data into a memory card because the data size in
ZM-300 is larger than the capacity of a memory card.
Write Protect: ON Cannot write data into a memory card because the write protect switch in
a memory card is ON.
Writing Error occurred. The error occurred while writing data into a memory card.
Selected data does not exist. The data in the reading target does not exist.
ZM-300 type is different. The specified type of the data in ZM-300 is different from the type of the
memory card data.
Selected data can not be read. The data in a memory card cannot be read.
Reading Error occurred. The error occurred during writing data into a flash ROM of ZM-300.
Data discrepant There is some discrepancy in data, when comparing data between a
memory card and ZM-300.
Screen data on ZM-300 will be
broken.
Warning about data destruction in ZM-300 that may occur when
transferring the font data larger than the present data from a memory card
to ZM-300. (The [OK] switch continues transferring; the [Cancel] switch
stops transferring.)
Undefined Error occurred. The error occurred due to some cause other than mentioned above.