Instruction manual

2
1. Operation of ZM-300 Main Menu 2-1
LCD Control Terminal Operations
1. Operation of ZM-300
Main Menu
Initial Screen
When the power of LCD Control Terminal is turned on for the first time, the Main Menu
screen shown below on the left is displayed.
Transferring Screen Data for the First Time
There are four methods for transferring screen data for the first time.
• Transferring screen data via the ZM-80C cable
Transfer screen data while the initial screen is displayed.
• Transferring screen data using the CF card or the memory card and the card recorder
(ZM-1REC)
1) Connect the personal computer with the card recorder and save screen data on the
memory card.
2) Insert the CF card into the ZM-300 unit or connect the card recorder and insert the
memory card into the card recorder.
3) Press the [CF Card (English)] switch. The “Card Menu”
screen is displayed.
4) Follow the instructions as described in “Card Menu Screen”
(page 2-11) and transfer screen data.
• Transferring screen data via Ethernet
1) Press the [IP Address (English)] switch.
2) The “Ethernet” screen is displayed.
3) Follow the instructions as described in “Ethernet” (page 2-24)
and set the IP address.
4) Press the [Setting Finished] switch. The initial screen displayed again.
5) Transfer screen data from the computer via Ethernet.
2002-4 -1 07:23:30
SYSTEM PROG. VER. 1.000
FONT
VER.1.300 / 1.000 / 1.000
ENGLISH
I/F DRV VER.1.240
MELSEC QnH Q
CPU Port
Editor:MJ1
Connection :
Signal Level :
PLC Stat. No. :
Multi-Link
RS232C
0
Baud Rate :
Data Length :
Stop Bit :
Parity :
Send Delay :
19200
8
1
Odd
2
0msec
Main Menu ZM-371TA
System Information
PLC Type : MITSUBISHIQnH(Q) series CPU
Comment :
Screen Data
Information
Size : 5783552
SRAM/Clock
Extension
RGB
Adjustment
Ethernet
Card
Menu
I/O Test
Error :
Time-Out :
Retry :
Stop
1.00 sec
3
Multi-Link2
Own Stat. No. : 1
 Total: 2
 Retry : 10
 Baud Rate : 115200
Multi-Link2
Own Stat. No. :
Total :
Retry :
Baud Rate :
1
2
10
115200
PORT : 10000
MAC : 050FF000035
Ethernet Information
Trans.Speed :
Stat. No. :
10BASE-T
192.168.1.68
Initial screen displayed when power is
turned on for the first time
Main Menu screen after transferring screen data