Instruction manual

1
22. Expansion Memory (ZM-300SM) 1-57
Hardware Specifications
Uninstall
Uninstall ZM-300SM in the following procedure. Before
uninstalling, discharge the static electricity in your body.
1. Turn off the power.
2. Remove the MEMORY cover on the rear side of the display.
3. Remove ZM-300SM. When removing it, use the ratchet of
the cover.
1) Insert the cover between the board and the display.
2) Pull up the cover, and remove the board.
4. Insert the removed cover until you hear clicking sound.
ZM-71SE setting
Select [SRAM/Clock Setting...] from the [System Setting (A)] menu, and set the
[SRAM/Clock Setting] dialog. See ZM-71SE Instruction Manual.
If you have changed the SRAM settings, be sure to format.
You can format ZM-300SM in the [Main Menu] screen. See the [Main Menu] screen below.
The [Main Menu] screen
You can check the current situation of ZM-300SM or format the SRAM in the [SRAM/Clock
Adjustment] screen of the [Main Menu] screen. To display the [SRAM/Clock Adjustment]
screen, press the [SRAM/Clock Adjustment]
switch.
1. The current situation appears beside the
characters of "Formatting SRAM".
When ZM-300SM is mounted: Extension
When ZM-300SM is not mounted: Built-in
2. To format the SRAM
Press the [Format] switch; then, press the
[Execute] switch.
When the SRAM is formatted, the
message "** Format Completed**"
appears.
If you remove ZM-300SM, the backup data disappears.
Note
Note
Use ZM-71SE, Ver.2.0.0.0 or higher.
(When using ZM-373TA/371TL/373TL, ZM-383S/383SA,
use version 2.1.0.0 or a newer version.)
MEMORY
CN6
1.
2
ratchet
Top
SRAM/Clock Adjustment
Main Menu
Date
Time
:
:
Formatting SRAM
*Formatting by current screen data type
**Format Completed**
Date and Time adjustment
Set
Extension
Format
Execute
2002-2-19 18 : 3 : 44
2002
17 18 0
71
2 19
::