Instruction manual

1
21. Expansion Memory (ZM-300EM) 1-53
Hardware Specifications
3. Put the slits of ZM-300EM with the projected parts of the display, and fix ZM-300EM into
the rear side of the display by pressing the connector part.
4. Insert the removed cover until you hear clicking sound.
5. Make sure ZM-300EM is appropriately installed in the [Main Menu] screen of the
display. When ZM-300EM is appropriately installed, the data size of the [Screen Data
Information] in the [Main Menu] screen is 8MB larger than before the expansion
memory is installed.
Uninstall
Uninstall ZM-300EM in the following procedure. Before uninstalling, discharge the static
electricity in your body.
1. Turn off the power.
2. Remove the MEMORY cover on the rear side of the
display.
3. Remove ZM-300SM. When removing it, use the ratchet of
the cover.
1) Insert the cover between the board and the display.
2) Pull up the cover, and remove the board.
4. Insert the removed cover until you hear clicking sound.
MEMORY
CN6
MEMORY
CN6
MEMORY
CN6
Put the slits (hole)
of ZM-300EM on
the projected parts.

Projected
parts
Press the connector part.
Top
SYSTEM PROG. VER. 0.131
FON
T
VER.
J
Connecti
o
Main Menu  ZM-3***
System Information
PLC Type:
Comment:
Screen Data Information
Size:13500416
MEMORY
CN6
1.
2
ratchet
Top