Instruction manual

1
17. Expansion I/O Module (ZM-322ME) 1-45
Hardware Specifications
ZM-71SE setting
Specify the following settings in port and memory on screen edit software ZM-71SE.
1. Port setting
Select [Expansion I/O] in [Modular Jack 1] or [Modular Jack 2].
2. Memory setting
Specify the addresses of both [DIO Input Mem.] and [DIO Output Mem.].
• The input memory corresponds to [IN 0 to 15], and the [DIO Output
Mem.]corresponds to [OUT 0 to 15].(Refer to page 1-43 "Terminal block
arrangement".)
Specifications
The general specifications of ZM-322ME are as follows: (see pp, 1-43 and 1-44 for the
information on input and output)
Note
Use ZM-71SE, Ver.2.0.0.0 or higher.
(When using ZM-373TA/371TL/373TL, ZM-383S/383SA,
use version 2.1.0.0 or a newer version.)
Rated voltage
Consumption current
Rushed electric current
Withstand voltage
Insulation resistance
Ambient temperature
Storage ambient temperature
Ambient humidity
Atmosphere
Vibration resistance
Shock resistance
Rectangular wave noise
Anti-static discharge
Grounding
Cooling system
Weight
Case material
Power supply
Physical environment
Mechanical working conditions
Electrical working conditions
Mounting conditions
Accessories
24 VDC+10%
Max.60mA
Max.1.5A (200)
Between DC external terminal and FG : 500 VAC, for 1 minutes
40. 10 M ohms or more in 500 VDC (between 24 VDC external terminal and case)
35 to 85%RH or less (without dew condensation)
No conductive dust and no corrosive gas
IEC1000-4-2 Compliant with IEC1000-4-2: 6kv in contact,
8kv in the air
D- grounding
47. Cooling naturally
Cooling naturally
Munsell 5Y3/0.5(dark gray), No painting at the bottom
Item Specifications
Vibration frequency : 10 to 150Hz, Acceleration : 9.8 m/s
2
3 directions of X,Y, and Z (one hour in each)
Pulse shape : Sine half wave, peak acceleration : 147m/s
2
3 directions of X, Y and Z (sixth time in each)
Exclusive cable (cable that connect ZM series MJ1 or
MJ2 and MJ1 of expansion I/O module : 2m)
One instruction manual