Instruction manual

1
13. 10BASE-T (LAN) 1-33
Hardware Specifications
13. 10BASE-T (LAN)
The connector for 10BASE-T is provided as standard on ZM-300 (high-performance). To
connect Ethernet with ZM-300 (standard), use the network module “ZM-80NU/80NU2.” If
ZM-80NU/80NU2 is attached to ZM-300 (high-performance), it has priority over the built-in
10BASE-T; 10BASE-T cannot be used.
10BASE-T Connector
• Use this connector for Ethernet connection.
- For ZM-360 (high-performance): - For ZM-370/380 (high-performance)
• The LAN (10BASE-T) pins correspond to signals as given below.
Side View Bottom View
CAUTION
MJ1/2 and LAN connector are 8-pin modular jacks. Check the name plate and
insert the connector in the correct position.
LAN Pin No. Signal Name Contents
1 TX+ Ethernet send signal (+)
2 TX- Ethernet send signal (−)
3 RX+ Ethernet receive signal (+)
4 NC Not used
5 NC Not used
6RX− Ethernet receive signal (−)
7 NC Not used
8 NC Not used
12345678