Instruction manual

5
1. SHARP PLC 5-1
Connection to PLCs
1. SHARP PLC
Link module
Communication Setting
The recommended communication parameter settings of the PLC and the ZM-300 series is as follows:
PLC
JW20, JW20H
JW30H
JW70(JW-70CU)
JW100(JW-100CU)
JW70H(JW-70CUH)
JW100H(JW-100CUH)
W70H, W100H
JW50, JW70, JW100
JW50H, JW70H, JW100H
PLC 2way
ZM-71SE PLC Selection
JW Series
JW100/70H
COM Port
JW20
COM Port
JW20(JW-22CU)
JW20H(JW-22CU)
JW10
JW30H
J-board
(Z-311J
Z-312J)
JW-1324K/1342K
JW-1424K/1442K
JW-1624K/1642K
JW-32CUH/H1/M1
JW-33CUH/H1/H2/H3
J-board
(Z-511J)
(Z-512J)
Link module
ZW-10CM
JW-10CM
Communication Port
JW-21CM
PG/COMM1 Port
PG/COMM2 Port
MMI Port
Communication Port
Upper Communication Port CN3
Upper Communication Port TC1
Z-331J/332J
Upper Communication Port CN8
Upper Communication Port CN12
PG/COMM1 Port
PG/COMM2 Port
Item Setting on PLC ZM-300 Comm. Parameter Setting
Baud rate 19200 bps 19200 bps
Port 0 for STA.NO ×10, 1 for STA.NO ×11
Parity Even Even
RS-422 4-wire system (fixed) −
Data length 7 7
Stop bit 2 2
Error check Sumcheck (fixed) −
Transmission mode Command mode (fixed) −