Instruction manual

4-14 1. Ethernet
ZM-71SE Setting (Network Table Editing)
To enable Ethernet communications on the ZM-300 series, the following network table
setting is required on the ZM-71SE editor.
Network Table
• The ZM-300 series, PLCs and PCs on the Ethernet must be registered on the network
table. In the case of the network illustrated below, the nodes with (∗) should be
registered on the network table.
• The network table is transferred to the ZM-300 series together with screen data.
When [Use Ethernet] is selected in the [Comm. Parameter] dialog, be sure to edit the
network table.
Ethernet-ready PLC
Server
Application
Server
Transfer
Screen data
I/F driver
Network table