Instruction manual

4-10 1. Ethernet
5. Check the IP address, and click [PC->].
6. Data transfer is started.
ZM-71SE Setting (PLC Type/Communication Parameter)
To enable Ethernet communications on the ZM-300 series, the following setting is required
on the ZM-71SE editor.
• PLC type setting
• Communication parameter setting
• Network table editing
In this section, the PLC type setting and communication parameter setting are explained.
Connection Example
There are two connecting methods between the ZM-300 series and the PLC.
(A) Connecting to the PLC through RS-232C or RS-485 interface
(B) Connecting to the PLC on the Ethernet
IP address for transfer target
S
erver
Ethernet-ready PLC
Application