Instruction manual

2
3. Errors Displayed on the ZM-300 Series 2-35
LCD Control Terminal Operations
2. Check
3. Warning
An error may be displayed on the Main Menu
screen during data transfer. This is a warning
message. For the warning details and solutions,
refer to the ZM-71SE Instruction Manual and
correct screen data.
Error Message Contents Solution
Screen No. Error There is no setting for
the received screen.
At the start of communications, the ZM-300 series
regards the value in the read area “n + 2” as the screen
number. Check that this value is an existing screen
number on the PLC.
Data has some error.
Error : XX (XX : XXX)
There is an error in the
created screen data.
“Error : XX (XX : XXX)” indicates the edited screen and
the contents of the error. For the error details and
solutions, refer to “ZM-71SE Instruction Manual” and
correct screen data.
Screen No. Error
Check
Communication Error
Check I/F driver
Check
Error Message Contents Solution
Communication Error
Check I/F driver
Although a request to
send is given to the
computer, no answer is
returned within the
specified time.
The I/F driver for simulator is transferred. If you don’t
use the simulator, uncheck [Use Simulator] before
transferring data.
2002-4 -1 21:52:36
SYSTEM PROG. VER. 1.000
FONT
VER.1.300/1.000/1.000
ENGLISH
I/F DRV VER.1.250
MELSEC QnH Q
CPU Port
Editor:MJ1
Main Menu ZM-371TA
System Information
PLC Type : MITSUBISHI QnH(Q) series CPU
Comment :
Screen Data
Information
Size : 5111808
Ethernet
Card
Menu
I/O Test
Data has some error.
Warning:207
SRAM/Clock
PLC Stat. No. : 0
Send Delay : 2 0msec
Retry : 3
Error : Stop
Time-Out : 1.00 sec
Connection : 1 : 1
Signal Level : RS232C
Baud Rate : 19200
Data Length : 8
Stop Bit : 1
Parity : Odd
Ethernet Information
Trans.Speed : 10BASE-T
Stat. No. : 192.168.1.68
PORT : 10000
MAC : 0050FF000035
Warning message