Instruction manual

2
1. Operation of ZM-300 Main Menu 2-29
LCD Control Terminal Operations
7. Extended Function Setting
When the [Editor: MJ1] switch on the Main Menu screen is pressed, the following
“Extended Function Setting” screen appears. Set the baud rate to be used when
transferring screen data between the ZM-300 series and a modem.
1. Select the desired baud rate using the [↑] / [↓] switch, and press the [Setting Finished]
switch. (Setting range: 4800, 9600, 19200, 38400, 57600, 115200)
* The function switches and switches on the Main Menu screen are not valid for 15
seconds after the [Setting Finished] switch is pressed.
* When the [Setting Finished] switch is pressed, an AT command is automatically sent to
the modem and the baud rate used between the ZM-300 series and the modem is set.
2. The Main Menu screen is displayed automatically, and “Modem Connect Mode” is
displayed below the [Editor: MJ1] switch.
3. To transfer screen data without a modem, select “Not used” for [Modem Comm. Baud
Rate]. To transfer screen data by connecting the ZM-300 series and the computer via
ZM-80C, select “Not used” for [Modem Comm. Baud Rate].
Main Menu
Extended Function Setting
Modem Comm. Baud Rate: Not used
Up Down
Setting
Finished
Up
Down
Setting Value
Pressing the [Editor: MJ1] switch brings up
the “Extended Function Setting” screen.
Pressing the [Setting Finished] switch
moves back to the Main Menu screen.
Editor:MJ1
 Retry
:
10
Modem Connect Mode
Ethernet Information
Trans.Speed : 10BAS
E
Stat. No. : 192.16
8
PORT: 10000
MAC: 0050FF000035
Baud Rate : 115200
Editor:MJ1
PORT : 10000
MAC : 050FF000035
Trans
.
Speed
:
Stat. No. :
10BASE-
192.168.
1