Specifications

300 SERIES MAN HOLE DIGGER
FORM GOM12070702, VERSION 1.2
16
operating instructions in this Operator's Manual are
directed with the Magura throttle control to be
assembled and operated in the configuration as
outlined in the Assembly section. Do not deviate the
assembly and operation of the Magura® throttle control
from that outlined in the Operator's Manual. FIGURE 4.
FIGURE 4
IMPROPER ASSEMBLY AND OPERATION OF
THE MAGURA® THROTTLE CONTROL WILL
REDUCE THE CONTROLLABILITY OF THE
HOLE DIGGER, RESULTING IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY.
5) Using the torque wrench, torque all handle
capscrews
evenly to 240 inch pounds (27 N.m.).
Excessive fastener torque values can lead to
subsurface fractures in the material and to
premature failure of the handle. Frequently
check the handle attach areas for signs of
cracking and fatigue. Replace any operator
handle of questionable structural qualities
with a factory replacement part only.
6) Route the throttle cable assembly into the guide
located on the handle reinforcement and into the
throttle cable attach bracket located on the engine
block under the air cleaner. The attach bracket has two
locations through which to route the cable. Route the
cable through the lower location. The attach bracket
should be in full contact with the aluminum end of the
throttle cable. Use the Phillips screw driver to
temporary secure. FIGURE 5.
FIGURE 5
7) Loosen the Phillips head screw on the throttle arm
swivel. Route the inner wire into the hole of the swivel
assembly. FIGURE 6.
FIGURE 6
8) Secure the throttle cable to the transmission cap
screw under the fuel tank with the supplied clamp. Do
not allow the clamp to crush the throttle cable.
FIGURE 7.