Technical data

EN/01.2010/CW/5
Transport, Installation
Area Cause Danger Safety note
Under the unit Defective lifting device Bruising Keep away from under the unit
Beside the unit Uneven or insufficient
foundation or raised floor
stand
Bruising by tipping
over of the unit
Make sure, the foundation is even
and stable and that the raised floor
stand is correctly mounted. Wear
protective equipment (helmet,
gloves, safety shoes).
In the lower part of
the unit
Heat by soldering flame,
sharp edges, built-in parts
Burns, cuts, concus-
sion damage
Wear safety glasses and gloves,
don't put your head into the unit.
Electrical box Connection cable under
voltage, sharp edges of
the openings for the cable
introduction
Electric shock, cable
damage at positioning
Check and make sure the unit is de-
energized. Stand on isolated ground.
Take care that sharp edges are al-
ways protected by rubber grommets
Start-up
Area Cause Danger Safety note
In the lower part
of the unit, water
piping
Leaks in the water lines
,
closed stop valves
Discharge of water under
high pressure, contact with
the skin of ethylen glycol, irri-
tation of eyes and respiratory
system by glycol vapours,
increased risk of electric
shock in combination with
electricity, risk of slipping
Open stop valves.
Wear rubber gloves, ethylen
glycol is absorbed by the
skin. Avoid swallowing water
with glycol additives
.
Fan outlet of
up-
flow units
Small parts fallen into the
fan
Small parts can be thrown
out of the fan when the unit
starts.
Ke
ep away from above the
fan outlet.
Fan, V-belt drive Unit operation
with open
doors.
Risk of injury by rotating
parts. Hanging parts of the
clothing or long hair can be
wound around the rotating
shaft.
Keep the distance to fan and
V-belt drive.
Tie up long hair, wear hair
protection.
Electrical box Short circuit Electric arc, acid vapours Retighten terminal connec
-
tions,
Wear protective gloves
2. Residual risks