Specifications

LD-22113-16
solvent, adhesive, resin, etc. which generate these gasses, causes corrosion and discoloration
of the modules. Therefore, please avoid these use. Epoxy resin (amino series curing agent),
silicone adhesive material (dealcoholization series and oxime series), Tray forming agent
(azo compound) etc, in the cabinet or the packing materials may induce abnormal display
with polarizer film deterioration. Be sure to confirm the component of them.
K) In case of attaching protective board (or tatch-panel, etc) over the LCD, be careful about the
optical interface fringe etc. which degrades display quality.
L) The LED used for thes product is very sensitive to the temperature. Luminance decreases
rapidly when it issued for a long time under the environment of the high temperature.
Please consult our company when it is used under the environment like the above
mentioned.
M) Please be careful that you don’t keep the screen displayed fixed pattern image for a long
time, since retention may occur.
N) Disassembling the module can cause permanent damage and you should be strictly avoided.
Please don’t remove the fixed tape, insulating tape etc that was pasted on the original
module.(Except for protection film of the panel.)
O) If a minute particle enters in the module and adheres to an optical material, it may cause
display non-uniformity issue, etc. Therefore, fine-pitch filters have to be installed to cooling
and inhalation hole if you intend to install a fan.
P) VCOM value have been set optimally before shipment, so do not change any adjusted value.
If adjusted value is changed, the specification may not be satisfied.
Q) Be sure to use a power supply with the safety protection circuit such as the fuse for the
excess voltage, excess current and or electric discharge waveform.
R) If you pressed down a liquid crystal display screen with your finger and so on, the alignment
disorder of liquid crystal will occur. And then It will become display fault. Therefore, be
careful not to touch the screen directly, and to consider not stressing to it.
S) If any problem arises regarding the items mentioned in this specification sheet or otherwise,
it should be discussed and settled mutually in a good faith for remedy and/or improvement.
(13) Packing Form (shown in Fig.4.)
Piling number of cartons ：MAX 10
Package quantity in one carton ：50 pcs
Carton size ：503 (W)×166 (H)×338 (D) mm
Total mass of one carton filled with full modules ：MAX. 7.5kg
Conditions for storage.
Environment
①Temperature ：0∼40℃
②Humidity ：60%RH or less (at 40℃)
No dew condensation at low temperature and high humidity.
③Atmosphere ：Harmful gas, such as acid or alkali which bites electronic
components and/or wires, must not be detected.
④Direct sunshine ：Please keep it in the state of wrapping or the darkroom so that
direct sunshine should not strike directly into the product.
⑤Asking for be dewy prevention
・Please do not put directly on the floor, and keep the wrapping box on the palette or the
stand to avoid the be dewy. Moreover, please arrange it in a constant direction correctly to
improve ventilation under the palette.
・Please separate from the wall in the storage warehouse and keep it.