Specifications

LD-22113-13
(10) Mechanical Characteristics
10-1) External Appearance
Do not exist extreme defects. (See Fig. 1)
10-2) Panel Toughness
The panel shall not be broken ,when 19N is pressed on the center of the panel by a
smooth sphere having 15 mm diameter.
Caution：In spite of very soft toughness, if, in the long-term, add pressure on the active
area, it is possible to occur the functional damage.
10-3) Input / Output Connector Performance
I/O connector of backlight driving circuit 【JST】
Lump connector
Symbol Used Connector Corresponding Connector
CN
A, B
BHR-02(8.0)VS-1N SM02(8.0)B-BHS-1N(assembled on PWB)
SM02(8.0)B-BHS-TB(assembled on PWB)
BHMR-03V (interconnecter)
(11) Display Quality
The display quality of the color TFT-LCD module shall be in compliance with the Incoming
Inspection Standards for TFT-LCD.
(12) Handling Instructions
12-1) Mounting of Module
① The TFT-LCD module is designed to be mounted on equipment using the mounting tabs in
the four corners of the module at the rear side.
Connect GND to these mounting tabs to stabilize against EMI and external noise.
On mounting the module, as the M2.6 tapping screw fastening torque is 0.3 through
0.5N･m is recommended, be sure to fix the module on the same plane, taking care not to
wrap or twist the module.
Don't reach the pressure of touch-switches of the set side to a module directly, because
images may be disturbed.
② Please power off the module when you connect the input/output connector.
③ Please connect the metallic shielding cases of the module and the ground pattern of the
inverter circuit surely. If that connection is not perfect, there may be a possibility that
the following problems happen.
a). The noise from the backlight unit will increase.
b). The output from inverter circuit will be unstable. Then, there may be a possibility that
some problems happen.
c). In some cases, a part of module will heat.
d).Please taking care to pull back-light’s cable, when you connect the back-light cable’s
connector.